Ghost 2 Immobiliser Problems
Designed to protect vehicles from key cloning and hacking The Ghost 2 immobiliser is a discreet device that can be installed without damaging your vehicle. It stops your car from starting until you press a specific sequence of buttons inside your vehicle similar to the password you enter on mobile phones.
Stop/Start
Ghost immobilisers protect vehicles from being stolen by stopping the engine from running until it is issued the correct PIN code. This is done without modification to the vehicle and is completely undetectable to thieves. The unit communicates with the ECU on the CAN data bus to immobilise the vehicle. This system is similar to the ones used by car manufacturers for a long time. However, thieves cannot bypass it with a new key or key relay technology, like they can using factory-installed systems.
Ghost Ghost can be fitted to any car, van motorhome, caravan, or bike with an engine and is compatible with all major brands of vehicles. The same system can also be utilized on electric vehicles. It is a great alternative to wheel clamps and steering wheel locks.
When the Ghost is activated, it will block all buttons in your car and prevent the ignition from starting without the PIN code. This can be done using the Android or Apple mobile app or by entering the code using your key fob. If a code that is incorrectly entered, the app will show an indicator light and the Ghost will not allow the vehicle to be started again. This is a great method to deter thieves. If the vehicle is unable to be started and they are unable to get it started, they will leave.
The Ghost is small weatherproof device that can be concealed in the most difficult-to-access parts of your car. It is extremely simple to install and takes an average of 20-30 minutes for each vehicle. It is also very simple to remove should you decide to switch your vehicle or give it away for service or valet parking. It is a TASSA (Tracking and Aftermarket Security Systems Association) insurance-approved system that is recognized by some insurers. It also comes with an emergency lock that is secure Pin Code Override, and a Service/Valet mode which can be activated by pressing a button in the app or using your key fob.
Disarm
Ghost immobilisers, unlike mechanical anti-theft devices that are able to be removed, are concealed in the car. Even if they were found, thieves would not be able to start the vehicle. They are virtually impossible to bypass or hack. This is because a ghost immobiliser blocks key cloning, signal jamming and device spoofing, all of which are methods that are commonly used by thieves to get into vehicles that have standard immobilisers.
An immobiliser works by sending an electronic code to the ECU (electronic control unit). If a wrong code is received and the vehicle does not start because the engine will not fire up. It is possible to disable a ghost immobiliser by using an application program, but it is extremely time-consuming and difficult to do so. Only an authorised installer can install and use the software.
The Ghost immobiliser is a small device that is part of the wiring loom of the vehicle and is inaccessible to the naked eye after it has been installed. It will not show up on diagnostic systems, it does not have LED indicators, and it does not communicate with the engine via the OBD port. It communicates in silence through the CAN data loop.
The system will not allow the vehicle to start unless it is provided with an input PIN code that is entered by the user. This code can be entered using buttons on the steering wheel, door panels, or the centre console. This is a much safer way to protect your car as it does not require the use of a key fob or remote control.
In addition to this Ghost also has an option for service that can be activated by using the application on your mobile phone. This will allow you to give your keys to someone else for valet parking or servicing without having to enter the disarm sequence.
ghost immobiliser fitting near me if your Ghost is in service mode or not you should never attempt to remove the system by yourself as it can affect the engine and cause damage. It is recommended to speak with an TASSA certified installer who can remove the system safely and properly. Our newest GHOST immobilisers come with a unique fingerprint QR sticker hidden in various areas of your vehicle. They are linked to our security register. If the device is removed and then is sold on the blackmarket it will be able to trace the original owner.
Anti-Hijack
The anti-hijack feature is an essential feature of the Ghost Immobiliser 2. It functions like a smart key and is among the most secure methods to keep your car safe from theft. The Ghost system will automatically activate the hazard light and stall the car's engine when the ignition is switched on and the vehicle is in a stationary position. This allows the driver and passengers time to press the hidden security button before the system is reactivated.
In contrast to other systems that simply stop the engine whenever the ignition is switched on The Ghost system uses a special controller and timer unit which will close the valve for cutting off fuel 14 in the event that it is activated within the set time even in the event that the ignition is turned on! The delay period must be sufficient to allow the owner of the vehicle to drive away and stay a safe distance from the car that it is stuck before the system can be activated.
In addition to the standard CANbus immobiliser blocking capabilities of the Ghost, it has an additional security feature that blocks common hacking methods employed to gain access to modern vehicles like relay attacks keys range extending, relay attacks and ECU swapping. This is because the Ghost system is completely silent and does not emit signals that can be picked up by thieves using RF scanning or code grabbing technology.
The Ghost system features the valet or service mode that allows your car to be re-started and driven without the requirement for a PIN code. This is perfect when you park your vehicle and need to be away for a short period of time, such as for example to put groceries in the boot, or open a garage door etc. The system will exit service mode depending on the speed and time or via the simple PIN code input process, giving you complete peace of mind that only YOU are able to use your vehicle!
Keyless Entry
Many consumers are now looking for extra security measures because of the increasing trend of car thefts using contactless technology. This is particularly relevant for those who have invested time and money into customising their car or own expensive automobiles. Immobilisers with add-ons can be an effective way to prevent this kind of theft, as they can prevent your car from starting until the correct pin code is entered, along with your key fob.
Immobilisers are designed to impede the various circuits in a vehicle, including those that control the starter motor and the fuel pump. They also are able to shut off the car alarm in order to draw attention to and frighten away any potential thieves.
These devices communicate with the engine control unit (ECU) through the CAN data circuit, and they stop a burglar trying to get around it by installing a brand new ECU or by using an engine key programmer. The immobilisers are fitted discreetly and leave no marks on your vehicle. They are also undetectable by sophisticated tools used by thieves.
In contrast to other systems that require a particular application, or a tag to be carried on the person carrying it, a Ghost immobiliser can only be deactivated by pressing a pattern of the existing electronic buttons on your steering wheel, door panel and centre console, allowing you to choose a custom pin sequence. The pin can be easily changed, making the device as secure as a credit card. It can also be more difficult to crack because it takes up to 20 presses.
Ghost also has the Valet/Service mode, which allows you to disable the system if your car will be handed over for valet parking or services which allows it to operate within predetermined parameters, like a 30mph speed limit, so you don't have to worry about your car being driven at a reckless speed. It can be activated with the original key or appropriate entry code.
This makes it the most effective and secure aftermarket CAN immobiliser available on the market. It is insurance approved by Thatcham as an add-on for your car when fitted by one of our authorised installers. The Ghost 2 immobiliser comes with six QR fingerprint labels and an ISR contact card with your unique QR codes as well as a secure emergency code. These are all kept in your purse or wallet.